IanH777
VIP Member
Harvey arrives on 25JUN and we would like to ask those of you who already own a GC680:
a. Any recommendations for a flat panel, high-def, Bluetooth monitor (we don’t watch tv, we just stream from iPads) on the aft wall of the seating area? No power cable on show.
b. A slim but secure mount for that to allow for swivel (not tilt) and where to go to get it fitted without Blu Tack, CopyDex or Velcro
c. We understand there is some safety netting in the rear overhead bin. Anybody managed to fit the two other bins on each side with same?
d. What are the dimensions of the sink base?
e. What are the dimensions of the wet room base (for a shower floor-liner)
f. We’re still searching for an alternative mattress but, until then, would a standard elasticated mattress cover and sheet work? If so, what would be best? King or SuperKing?
g. Has anybody fitted a skid-plate for the engine, differential and water tank.
h. Has anybody had a ceramic coating applied?
Many thanks for your time.
We are so excited, we are almost vibrating...
a. Any recommendations for a flat panel, high-def, Bluetooth monitor (we don’t watch tv, we just stream from iPads) on the aft wall of the seating area? No power cable on show.
b. A slim but secure mount for that to allow for swivel (not tilt) and where to go to get it fitted without Blu Tack, CopyDex or Velcro
c. We understand there is some safety netting in the rear overhead bin. Anybody managed to fit the two other bins on each side with same?
d. What are the dimensions of the sink base?
e. What are the dimensions of the wet room base (for a shower floor-liner)
f. We’re still searching for an alternative mattress but, until then, would a standard elasticated mattress cover and sheet work? If so, what would be best? King or SuperKing?
g. Has anybody fitted a skid-plate for the engine, differential and water tank.
h. Has anybody had a ceramic coating applied?
Many thanks for your time.
We are so excited, we are almost vibrating...