acer
VIP Member
I want to drill two 6mm holes into the metal panel on the side of the rear bench seat. To be clear, this is near to where there is already a similar sized hole - in fact the left-hand hole will be almost directly underneath it by about 4 inches, and the right-hand hole will be horizontally level with this about 4 inches across.
I know many people use the Brandrup pouches stuck on with double-sided tape and Velcro fixings, but I always find that they end-up slipping off - especially in the sun. And, anyway, I've made myself a little box to go here to hold sun-cream, soap and hand-gel bottles etc that for us will work much better. I've even bought some fixings that will protrude less than 2cm into the cavity that sits in there.
Has anyone done something similar?
More importantly, does anyone know if I might hit something important as I am drilling?
I know many people use the Brandrup pouches stuck on with double-sided tape and Velcro fixings, but I always find that they end-up slipping off - especially in the sun. And, anyway, I've made myself a little box to go here to hold sun-cream, soap and hand-gel bottles etc that for us will work much better. I've even bought some fixings that will protrude less than 2cm into the cavity that sits in there.
Has anyone done something similar?
More importantly, does anyone know if I might hit something important as I am drilling?